Cellular Blinds Care and Maintenance Instructions
OPERATING
Standard Blinds Corded:
- To raise blind, pull lift cord till blind reaches desired position then jolt gently. Lock mechanism will engage.
- To lower the blind, grab cord and jolt gently and allow cord to slide slowly through fingers till blind is fully lowered or reaches the desired position. If desired position is not the bottom jolt cord to engage lock.
Standard Blinds Cordless:
- To raise or lower blind simple grab bottom rail and raise or lower to desired position.
Top Down Bottom Up Corded:
- To lower blind in top-down position, grab cord, jolt to release lock mechanism and either lower blind fully or to desired position.
- To raise blind from bottom grab cords and raise blind to desired position. Jolt cord to engage lock mechanism.
- Note that top-down part of blind must be raised before bottom up part of blind can be raised.
- Top-down part of blind will stack to about 1/3 of drop when lowered down.
Top Down Bottom Up Cordless:
- To lower blind in top-down position, grab mid rail and guide blind to desired position.
- To raise blind from bottom grab bottom rail and raise blind to desired position.
- Note: the top-down part of blind must be raised before bottom up part of blind can be raised.
- Top-down part of blind will stack to about 1/3 of drop when lowered down.
CLEANING
- To keep them clean on a daily basis, run a feather duster lightly over the cloth surface.
- If you have a vacuum, use the brush attachment and without using any pressure, sweep both front and back sides of the blind panel.
- To clean cell simply hold fabric and use accessory of vacuum clean to draw out dust or insects
- To spot clean any stains or stubborn dirt, gently dab a soft cloth that has been dampened with a very weak mixture of water and dishwashing soap.
- Once the stain has lifted, gently dab again with a soft cloth dampened with clear water and then once more with a dry cloth to absorb as much moisture as possible.
